If you have a Pro Trinket you probably comprehend it’s the perfect little size for a portable project. This LiPoly backpack makes it in reality easy to do! Instead of wiring 2 or 3 boards together to make a charging system, this little PCB sits on top of the Pro Trinket and allows a LiPoly/LiIon battery to plug in. When the Pro Trinket USB port is powered, the battery is recharged automatically. Unplug the USB port and the Pro Trinket will switch over to the rechargeable battery. Ideally, this backpack is for use with the 3.3V Pro Trinket, so that the battery voltage (3.7V-4.2V) will get regulated down to 3.3V on the Pro Trinket board. On the other hand, many times, you’ll be able to run a 5V Pro Trinket + accessories off of the ~4V from the LiPoly battery with no problem. (Technically its overclocking but we’ve never seen that impact the Pro Trinket itself, AVRs are happy to overclock without complaint). Solder the backpack on with the extra long header so that it can still plug into a breadboard, or clip the long header leads short afterwards for a slim package. There are two LEDs – one red and one green. Whilst charging, the red LED is lit. When the battery is fully charged and ready for use, the green LED turns on. Seriously, it could not get more easy. If you wish to add an On/Off switch, we also made that in reality easy. The two 0.1″ holes with a box around them are the battery output line. Carefully cut the trace between them with a hobby knife and replace with two wires from a switch like this slide switch, or this pushbutton one, for example. Charging is performed in three stages: first a preconditioning charge, then a constant-current fast charge and finally a constant-voltage trickle charge to keep the battery topped-up. The charge current is 100mA by default, so it is going to work with any size battery and USB port. If you wish to have you’ll be able to easily change it over to 500mA mode by soldering closed the jumper on the bottom, for when you can only be charging batteries with 500mAh size or larger.
Make sure this fits by entering your model number.
Ideally for use with the 3.3V Pro Trinkets & ItsyBitsy
Charging is performed in three stages
Will work with any size battery and USB port
Reviews
There are no reviews yet.