Jetson Nano Case (C) Assembly
1.Remove the Jetson nano, assemble the wireless module and replace it.
2.Mount the buttons on the metal box, note that the button with four wires is the Power button and another which has two wires are the Reset button.
3.Connect buttons to Jetson Nano, please refer to the diagram. Insert the micro SD adapter board to the Micro SD slot of Jetson nano. Press it to let it locked. Note that you will have to press the adapter to ensure that the adapter is pop-up, then remove it. You can not directly pull it out, differently you are going to break the Micro SD slot.
4.Adjust the cables, mount the Jetson Nano developer Kit in the Metal box and fix it by screws. You will have to also fix the Micro SD adapter board by screw.
5.Fix the Jetson Nano GPIO adapter board in metal box by skews.
6.Fix the antennas of the wireless module on the metal box. Assemble the cooling fan.
7.Connect Jetson nano to the GPIO adapter by cable.
8.Fix the camera holder-bottom on the metal cover.
9.Fix camera on camera holder-top by nylon screws.
10.Assemble camera holders by screws, adjust the angle and turn it tightly..
11.Connect the cable cables to Jetson Nano (you’ll be able to first remove it from cameras), When you have only one camera, just want to connect one cable.
12.Assemble the case, connect the Camera and antennas.
For more information about Assembly, please check in the wiki :https://www.waveshare.com/wiki/Jetson_Nano_Case_(C)?Amazon
Package Content
- Body case (top and bottom)
- Camera holder bottom mount
- Camera holder top mount
- Jetson Nano adapter board
- Micro SD card adapter board
- Flat ribbon cable 2*20PIN
- Spanner
- Screwdriver
- Button with 2PIN wires
- Button with 4PIN wires
- Screws pack
- Jumper
Make sure this fits by entering your model number.
Jetson Nano Developer Kit Compatibility–The case Compatible with Jetson Nano Developer Kit Original Version and New Version B01
Special Camera Holder–Mounting Holes For Single Camera Or Binocular Camera, Up To 180° Roll Angle
Invisible Cooling Fan–Heat Dissipation Through The Airflow Vent On The Top, More Elegant Design(The fan isn’t included)
RESET And POWER Buttons–With System Status Indicator (B01 Only, NOT To be had For The Original Version)
Enabling The 4G Communication–Allows Installing 4G Module Inside,Recommendation: SIM7600G-H 4G for Jetson Nano
Reviews
There are no reviews yet.