Hey Mr. DJ! Turn up that Raspberry Pi mix to the max with this cute 3W Stereo Amplifier Bonnet for Raspberry Pi. (It isn’t big enough to be an official HAT, so we called it a bonnet, you see?) It’s the exact same size as a Raspberry Pi Zero but works with any and all Raspberry Pi computers with a 2×20 connector – A+, B+, Zero, Pi 2, Pi 3, etc. We’ve tested it out with Raspbian (the offical operating system) and Retropie.
This Bonnet uses I2S a digital sound standard, so you get in point of fact crisp audio. The digital data goes right into the amplifier so there is no static like you hear from the headphone jack. And it’s super easy to get started. Just plug in any 4Ω to 8Ω speakers, up to 3 Watts, run our installer script on any Raspberry Pi, reboot and you’re ready to jam!
Each order comes as a fully tested PCB with a 2×20 header and 2x terminal blocks. Some light soldering is required to attach the header onto PCB so you’ll be able to plug it into your Raspberry Pi. Once that’s done either plug one of our enclosed speaker sets right into the JST jack in the middle or you’ll be able to solder the terminal blocks in and then connect any speaker you like like our 4Ω 3W or 8Ω 1W. Hey you’ll be able to even use a surface transducer!
Our tutorial will get you set up with instructions, you’ll be able to be rockin’ out in 15 minutes.
Don’t disregard to you’ll want to have a good strong 5V power supply – especially if you are the usage of the 3W 4 ohm speakers! Our 2.4A power plug is advisable.
Pi Zero and speakers not included!
Make sure this fits by entering your model number.
3W Stereo Amplifier Bonnet for Raspberry Pi
I2S digital sound standard interface
Plug any 4 ohm or 8 ohm speakers
Operating Voltage: 5V (2.4A for 3W 4 ohm speakers)
Works with Raspberry Pi with 2×20 headers (A+, B+, Zero, Pi 2, Pi 3, etc)
Reviews
There are no reviews yet.